Call us on 01278 441500

Raleigh Cotter Pins Continental 9.0 mm - Pair

Customer Reviews (1)
1 / 5| Write your review
£3.99
was
£3.99 Please note this product has selling restrictions to your country. was
Manufacturer : 
SJS Cycles part number : 
Manufacturer part number : 
Details
Many older bicycles use wedge-shaped fasteners called "cotters" to hold the cranks onto the bottom bracket axle.
These cotters have a nut to hold them in place after they have been driven or pressed in.
They can be difficult to remove, especially if they have been in place for a long time
The diameter of the round part of the cotter tends to be standardized according to nationality. Most use 9.5mm, including British, Asian and most German bicycles. French and Italian bicycles used 9mm, or sometimes 8.5mm
Product Reviews (1)
Questions & Answers (3) Q & A
Specification
Downloads
Download File  
Product Reviews (1)
Overall Product Rating 1 / 5
Didn't fit my old Raleigh
By Nikolas M
23 Apr 2020
1 / 5
Conspoor compatibility
These Raleigh cotter pins didn't serve me. The diameter is 0.5mm too small for my Nervar crank. Also the wedged side wouldn't fit without filling.
Questions & Answers (3)
suitability
By
14 Apr 2020
Hi,
i have a 1980's 3 speed Raleigh BSA. Standard pins i bought on ebay are 9.5mm diameter and too wide. Measuring the old ones they turn out to be 9mm. However the taper on the old ones go three quarters of the way down, whereas you say these stop half way along. Old ones dimensions are 42.5mm total length, with the main body being around 2.9mm in length and the remainder the thread.
Your ones seem more or less the same dimensions, but will the short taper be a problem?
Also, what is the material, is it hardened steel?
Thanks.
Hi, yes the shorter taper may be a problem. However I don't think you have many options. There is no indication they are made of hardened steel. So they may be worth a try. Thanks 14/04/2020
Raliegh Replacement Pins With Longer Taper?
By
25 Sep 2016
Hi, I need to replace a pin on my old Raliegh crankset.

The pins I have removed are 9mm Diameter 31mm length to the main body with 2mm of thread. Also the taper on them goes to about 5mm from the head of the body. Will these pins fit?
Hi,

It is unlikely these pins will fit I'm afraid as the dimensions are quite different. The main body is 30mm in length and there is 12mm of thread. The taper stops half way along the main body.

Thanks.
Shape Of The Tapper
By
23 Oct 2014
Hi,

in the picture, there appear to be two different pins. One has the tapper from the tread all the way down to the bottom, and the other seems to have a shorter tapper.

Which one would I be buying?

Regards,

Samuel
Hi,

Its hard to tell in the photo, but they are both the same. They come with a short taper that finishes half way along.

Thanks.