Dia-Compe 1281-F Front Brake Cable Hanger

£17.99
was
£17.99 Please note this product has selling restrictions to your country. was
Manufacturer : 
SJS Cycles part number : 
Manufacturer part number : 
Details
Front cable hanger

Fork mounted steel brake hanger

Fits to caliper hole
Product Reviews (0)
Questions & Answers (3) Q & A
Specification
Downloads
Download File  
Be the first to write a review
Feel free to leave a review of this product, good or bad it helps other customers with their buying decision.
By Anonymous
02 Dec 2023
5 / 5
I recommend this product
A good stylish piece. I fitted it to a steel fork crown, 1inch steerer tube, with an Old school Campagnolo Super Record Headset. This then required spacing out with two drilled out 6mm stainless Hex nuts to miss the headset Crown race. The captive bolt is just long enough for this with a 6mm Nylock on the back. I needed to fit the hanger first then mount the Crown race as I had a threaded rear section on the Crown for extra security.
Good quality, some flaws
By STP
25 Sep 2020
4 / 5
ConsCable catcher runs low
ProsSolid fit with no flex
Fitted to old Dawes Horizon touring bike with a couple of half moon washers. Product looks good, but cable catcher is a bit deep and just rubs on 35mm tyres, so some filing was required.
Solid & Firm
By JH
05 Oct 2018
5 / 5
I recommend this product
ConsBolt Length
ProsGood Design
Another well made item from Dia-Compe.
Unfortunately the bolt was not long enough to go through the fork crown on my touring bike, one found suitable in my workshop however. Also a deeper washer required to clear the steerer bottom crown. Apart from this minor problem I recommend the item.
Questions & Answers (3)
What is the measurement from the bolt hole - bottom of the cable stop?
By
18 Jan 2020
Need to know if the hanger is tall enough to work with my straddle wire.
Hi, it is 50mm. Thanks 20/01/2020
Is this a steel or alloy brake hanger?
By
24 Oct 2017
Hi,

This hanger is made from alloy.

Thanks.
Compatibility
By
31 Aug 2017
Hi,
Can it be used with the Dia Compe Gran Compe 610 center pull brakes
Hi,

Unfortunately this cable hanger will not work with the 610 brake as they both need to mount to the fork crown fixing bolt. This cable hanger is designed for use with cantilever style brakes the mount lower down on the forks.

Thanks.