RJT 3 Speed Freewheel 3/32 16 - 22

You mention using the SPA-6 pin tool but I think just removes the facia plate exposing the bearings. In my experience, it does not remove the freewheel.

Can you check with the supplier what tool it requires?

FWIW, and in answer to another question, the indexing is in the adjuster, not the derailleur. You can use whichever one you want. Just use a non-indexed, friction style adjuster.

(From memory, I think it's a 2 pin remover with a 38mm outer, but suspect most people will just use a destructive method to remove it).

Thanks.

Do you remove the ring using the two dimples for leverage turning in the direction indicated? I assume you then access the bearings which you remove and then lift of the sprockets? You would then take off the centre piece using an adjustable spanner?

Which rear derailleur would you recommend using with this freewheel?

I'm wondering if I can slip it onto Sturmly automatix on an old fixie

Is this to build a 6-speed derailleur bike? I'm looking to upgrade my Moulton APB from the rubbish Sturmey Archer 5-speed hub to something lighter and I want a simple, traditional derailleur system.