DT Swiss Ring Nut Tool for Pawl Drive Rear Hubs

Customer Reviews (1)
4 / 5| Write your review
£59.99 Please note this product has selling restrictions to your country. was
Manufacturer : 
SJS Cycles part number : 
Manufacturer part number : 
- Ring Nut tool required for removing and replacing inner bearings on pawl drive rear hubs, which are located behind the internal ring nut
- Only works on Pawl hubs as used on DT complete wheels, for ratchet and aftermarket hubs please use tool HBDT835
- Simple to use, and fits into a vice for workshop use, do not over tighten the vice in use as this can crush the tool
Product Reviews (1)
Questions & Answers (1) Q & A
Download File  
Product Reviews (1)
Overall Product Rating 4 / 5
Worked fine
By Nick J
22 Mar 2020
4 / 5
I recommend this product
ConsBit expensive for a one use tool
ProsGet the right one
Undo anti-clockwise was tight needed a good shove
Questions & Answers (1)
Ratchet ring Remover for a Fulcrum Red Power hub.
25 Nov 2020
I am looking for a Ratchet Ring Remover for a Fulcrum Red Power hub - would that by any be similar to the DT-Swiss HBDT5266?
As we don't sell Fulcrum products we cannot advise, i suggest you contact the manufacturer directly for assistance.

JK 25.11.20