20 x 1.75 Rear Wheel with Nutted Solid Axle & Alloy Rim Screw on Freewheel Type - 36 Hole

We have not tried to do this therefore we cannot say for sure, it is possible but depending on sprocket used it may cause interference issues with the frame. SK 06/06/23

The hub uses an ISO thread of 1.375 x24, the smallest sprocket you can fit is a 16T at 1/8th pitch. SK 14/03/23

Thank you for your enquiry, it will be single wall

WD 10/11/21

Thank you for your enquiry, it would be suitable for geared freewheels

WD 03/06/21

I doubt it, this is an older wheel what takes freewheels- not cassettes- so no cross-compatibility. I would contact Raleigh to get the exact specification of the rear wheel used, only then can we guarantee a 1:1 replacement product.

This will be dependant on how many gears you choose to use. Most average freewheels would work.

Thanks - 08/10/19

It's for a single screw on freewheel so pretty much symetrical RT

Hi,

This wheel can't accept a cassette as it is only designed for a screw on freewheel. You may need to adjust the axle spacing to allow you to fit an 8spd freewheel onto this wheel. All of the 8spd freewheels we stock share the same thread so providing there is space to fit an 8spd freewheel any we sell will be suitable.

Thanks.

Hi,

Unfortunately as we're not a Dahon dealer I can't say for sure if it will fit or not. It will fit providing your bike uses a 135mm spaced rear dropout. Also this hub uses a screw on freewheel which doesn't accept a normal cassette which your bike would have been originally supplied with.

Thanks.